English to Russian air-liquid coolers and condensers instruction manual

Search term or phrase in this TERMinator '. "." . '

Purchase TTMEM.com full membership to search this dictionary
 
 
Share this dictionary/glossary:
 

 
database_of_translation_agencies
 

SourceTarget
These units BCM and BDM are available in five noise levels fan motor, (S) standard, (L) low, (Q)quiet, (R) residential and the new (T) high performance fan:Блоки BCM и BDM представлены 5 разными моделями в зависимсости от шумового уровня двигателей вентиляторов: Вентилятор со стандартным уровнем шума (S), (L) низким, (Q) тихим, (R) для жилых зон и новые вентиляторы высокой производительности (T):
UNITSБЛОК N°
Special care should be taking in following the minimum distances recommended, particularly in cases for installations with two or more units, either horizontal or vertical, in areas with strong winds.Будьте внимательны и соблюдайте минимальные рекомендованные расстояния, особенно, при установке нескольких вертикальных или горизонтальных блоков в зоне с сильными ветрами.
Vibrations' Isolator Each Kit contains 2 unitsВиброопоры Каждый комплект содержит 2 шт
All units are supplied with supports for vertical installation but, if requested, kits with supports and screws for horizontal mounting can be provided.Все блоки имеют опоры для вертикальной установки, но по запросу может быть поставлен и комплект для горизонтальной установки.
Lift the unit and secure its legs.Приступить к подъему блока и закрепить ножки.
Move the eyebolt and make sure that it is tightened before lifting the unit.Перед подъемом блока переместить рым-болт и проверить, чтобы он был затянут.
Use a rocker arm to lift the unit.Поднять блок, используя рычаг.
The min. lifting angle between the belts and the unit must be60°.Минимальный подъемный угол между тросами и блоком должен быть 60º.
If the unit requires emptying for maintenance or system shutdown, proceed as follows:Если для техобслуживания или во время стоянки оборудования необходимо опустошить аппарат, сделайте следующее:
When drainage is completed, ice formation is prevented by adding to the unit the amount of anti-cooling mix shown in TAB.3.После слива позаботьтесь о том, чтобы не образовался лед, для этого введите в блок незамерзающий раствор согласно таблице.
When the unit should be emptied for maintenance or when the system is not in use, the following procedure should be performed:При необходимости опустошения аппарата для выполнения операций по техобслуживанию или когда установка не работает выполняйте следующие действия:

Want to see more? Purchase TTMEM.com full membership