Source | Target | Indicate that special procedures must be followed to avoid serious injures to people. | Indica procedure speciali che devono essere seguite per evitare seri danni alle persone. |
Indicate that special procedures should be followed to avoid serious damages to the equipment. | Indica procedure speciali che dovrebbero essere seguite per evitare seri danni all'apparecchiatura. |
Pay attention to the following instructions to avoid serious injures to people and/or damages to the equipment. | Seguire attentamente le seguenti istruzioni per evitare seri danni a persone e/o danneggiare l'apparecchiatura. |
Before performing any maintenance operation, the power supply from the general board should be switched off, and the safety switch should be in the OFF position to avoid accidents. | Prima di eseguire qualunque operazione di manutenzione, disinserire l'alimentazione dal quadro generale e posizionare su OFF l'interruttore di sicurezza per evitare eventuali incidenti. |
Avoid the installation in closed locations. | Evitare di installare l'apparecchiatura in luoghi chiusi. |
To avoid the oxidation of the equipment's legs, it is recommended to lean them on concrete bases of about 4 inches (10 cms.) high (one base for each leg). | Onde evitare l'ossidazione dei piedi dell'unità si raccomanda di disporre la stessa su un basamento alto circa 4 pollici (10 cm) (un basamento per piede). |
To avoid the water hammer effect, regulating valves (preferably) should be installed at the input and output of the external circuit of the equipment. | È possibile evitare l'effetto del colpo di ariete installando delle valvole di regolazione (preferibilmente) all'ingresso e all'uscita del circuito esterno dell'apparecchiatura. |
For further security, the operator can also turn the switch ON/OFF to the OFF position to avoid accidents. | Per un'ulteriore sicurezza ed evitare incidenti l'operatore potrà spegnere (OFF) l'interruttore ON/OFF. |
Verify that the electric connection terminal studs are properly tight, to avoid losses and wear due to sparks. | Verificare che I morsetti delle connessioni elettriche siano correttamente serrati per evitare eventuali perdite e usura causate da scintille. |