English to Italian air-liquid coolers and condensers instruction manual

Search term or phrase in this TERMinator '. "." . '

Purchase TTMEM.com full membership to search this dictionary
 
 
Share this dictionary/glossary:
 

 
database_of_translation_agencies
 

SourceTarget
This instructions' manual is intended to be your permanent guide for the different situations you may encounter when using this equipment.Questo manuale d'installazione è stato creato per fungere da guida permanente per le diverse situazioni che potrà incontrare usando quest'apparecchiatura.
This equipment is designed to operate properly and produce rated capacity when installed in accordance with accepted industry standards.Quest'apparecchiatura è progettata per operare correttamente e produrre la capacità specificata quando installata conformemente alle norme industriali standard.
Whenever Fans maintenance task should be carry out, be sure they are not running and the security switch is in the OFF position.Ogni qualvolta si renda necessaria la manutenzione dei ventilatori assicurarsi che questi non siano in movimento e che l'interruttore di sicurezza sia in posizione OFF.
When the operation is completed, place back the corresponding protection.Al termine dell'operazione reinserire la relativa protezione.
When walls are present, follow the distances recommended by ...Quando sono presenti dei muri attenersi alle distanze consigliate da ...
When the whole air in the equipment was discharged, close the vent valve.Dopo aver spurgato completamente l'aria dall'impianto, chiudere la valvola di spurgo.
Control that the current load indicated on a current clamp tester is equal or slightly lower than the rated, when the fan(s) are running at rated rpm.Verificare che il peso attuale indicato dal tester della corrente a morsetti sia pari o poco inferiore a quello nominale quando il/I ventilatore/i funziona/no a velocità nominale.
When drainage is completed, ice formation is prevented by adding to the unit the amount of anti-cooling mix shown in TAB. 3.Terminato lo scarico, prevenire la formazione di ghiaccio inserendo nell'unità la quantità di miscela antigelo indicata in TAB. 3.
Follow the start-up procedures whenever the equipment is started up.Ripetere queste operazioni per ripristinare il funzionamento dell'impianto.
When the unit should be emptied for maintenance or when the system is not in use, the following procedure should be performed:Quando è necessario svuotare l'unità per eseguire la manutenzione oppure quando l'impianto rimane inattivo durante l'inverno, seguire la procedura descritta di seguito:
When not in use, leave the equipment loaded with dry nitrogen.Durante il periodo di inattività caricare azoto secco nell'impianto.
Use an ammeter to check that the current absorbed is equal to or slightly lower than the rated value when the fan(s) work(s) at rated speed.Verificare con un amperometro che la corrente assorbita sia pari o leggermente inferiore al valore nominale quando il/i ventilatore/i funziona/no a velocità nominale.

Want to see more? Purchase TTMEM.com full membership